Surface Protection Issues

When using adhesive surface protection products on a job site there may be always a small risk of adhesive transfer. Improper installation, high temperatures, high visitors, and surpassing the beneficial ‘remove by’ date can all lead to problems with carpet masks and films. Following are a couple of recommendations to keep away from any adhesive transfer.

Always observe the producer’s suggestions when using carpet films. Carpet film utilization scores range from 30 to 60 days. Leaving the film on carpets previous the really useful usage rating invalidates all manufacturers’ warranty.

Use films made in the USA for the very best warranty protection and highest quality.

Carpet films use either water based or solvent based adhesives. Water based adhesives are simpler to remove if a problem occurs.

By no means set up adhesive carpet protection on wet or damp carpet.

Never set up adhesive carpet protection over glue down carpet for at least seventy two hours to allow the glue to “breathe”.

If carpet has been put in over a newly poured cement slab that isn’t totally cured, keep away from using adhesive carpet protection as it can trap the cement moisture and discolor the carpet.

In cases of utmost heat, shorten the beneficial time of application by 50%.

As said on the installation directions of every film producer, there is no warranty offered for application on wool carpets.

If the above steps are taken, the possibility of any adhesive switch when using a carpet film is negligible. Within the cases the place steps have NOT been adopted, one in all these points might happen: 1) sticky adhesive residue on carpet, or 2) discoloration of carpet the place the plastic was used. It’s important at this step to know the type of adhesive used, water or solvent based.

Water based adhesive film residue easily removes with warm water and might be quickly removed via steam cleaning the carpets. Solvent primarily based adhesive residue can also be removed via steam cleaning however it may take more than one cleaning to totally remove the adhesive. Citrus cleaners available at any hardware store can sometimes aid within the removal of solvent primarily based adhesive residue. If further problems persist, contact your native surface protection supplier to discuss different potential solutions.

Discoloration of carpet is caused by the trapping of moisture under the film and the following response of the moisture and the chemicals in the plastic film. Unfortunately this situation can only be remedied by removal of the affected area of carpet. This situation happens most commonly in cases where users have carpeted over slabs that were not totally cured.

Should you loved this short article and you wish to receive much more information about temporary floor protection please visit the web site.

One Response to Surface Protection Issues

Leave a Reply

Your email address will not be published. Required fields are marked *